|
发表于 2014-5-31 14:08:11
|
显示全部楼层
现在是 煤气控制旋钮 无法像说明中说的旋转至 off位置.是不是我直接关总阀赵成的.
以下是说明的扫描:
LIGHTING INSTRUCTIONS
1. STOP. READ THE SAFETY INFORMATION ABOVE.
2. TURN THE GAS CONTROL KNOB CLOCKWISE TO THE "?” (OFF) POSITION.
3. WAIT 5 MINUTES SO ANY BUILD UP OF UNBURNT GAS CAN ESCAPE. IF YOU THEN SMELL GAS, STOP. FOLLOW “C" IN THE SAFETY INFORMATION ABOVE. IF YOU DO NOT SMELL GAS, PROCEED TO STEP 4.
4.Turn the gas control knob to the '^?"(pilot) position.
5.Depress the knob fully (until disappears below housing) and after thirty (30) seconds, whilst keeping the gas control knob depressed, repeatedly press the igniter button (for up to 40 seconds) until the pilot flame ignites.
WARNING: Keep your face clear of the combustion chamber opening while pressing the igniter.
NOTE: it is not possible to depress the knob fully if the gas control has activated its safety shut off feature. In this case, wait 60 seconds for the gas control to reset.
6.Keep the knob depressed for twenty (20) seconds after the pilot flame lights.
7.Release the knob and check if the pilot is still aligt. The pilot can be checked by looking through the large opening below the gas control.
8.If pilot has failed to light or has not remained alight, turn the gas control knob to the "?’’(off) position. Wait 5 minutes for the escape of unburnt gas, and then begin again at step 4.
NOTE: Failure to wait 5 minutes may result in a fire or explosion.
9.When the pilot flame remains alight with the gas control knob released, turn the knob anticlockwise to one of the number settings. A setting of "6” is recommended; this will provide a water temperature of about 60 C.
10.Turn the knob to a higher number for higher water temperatures or a lower number for lower water temperatures.
11.Replace the access panel.
12.If the burner does not light at the selected setting, the water may already be at the selected temperature. |
|