|
|
发表于 2014-6-1 01:10:43
|
显示全部楼层
原帖由 Hi5 于 2012-4-17 19:18 发表
菲闻啊!你听谁说的??????????????
KNOX PLANNING SCHEME
SCHEDULE 2 TO THE DESIGN AND DEVELOPMENT OVERLAY
Shown on the planning scheme map as DDO2
DANDENONG FOOTHILLS: LOWER SLOPE AND VALLEY AREA
1.0 Design objectives
? To ensure that residential development reflects the existing subdivision character of the
area.
? To ensure that lots are large enough to accommodate development, while retaining
natural or established vegetation cover and providing substantial areas for planting and
revegetation to occur.
? To minimise site coverage and impervious surface cover to protect environmental
values and minimise the visual dominance of development.
2.0 Buildings and works
The following requirements apply to development:
? The site area covered by buildings must not exceed 40%.
? The site area covered by buildings and impervious surfaces must not exceed 60%.
A permit cannot be granted to construct a building or construct or carry out works which
are not in accordance with these requirements.
A permit is not required to extend an existing dwelling or construct buildings and works
ancillary to a dwelling (including a water tank of 4500 litres capacity or less) if:
? The site area covered by buildings does not exceed 40%.
? The site area covered by buildings and impervious surfaces does not exceed 60%.
? There is only one dwelling on the lot and the area of the lot is greater than 500 square
metres.
? The height of the building or works is less than 7.5 metres.
? A proposed outbuilding has a floor area less than 50 square metres, wall height less
than 3.6 metres and overall height less than 5 metres.
? Proposed excavation or filling is less than one metre in depth.
? Excavation or filling is not occurring within the root zone of vegetation that would
require a permit for its removal, destruction or lopping.
? The slope of the land is less than 10%.
? External surfaces, including roofs or all buildings but excluding solar panels, utilise to
the satisfaction of the responsible authority non-reflective materials coloured and
maintained in muted tones of green or brown.
Subdivision
Land in the Residential 3 Zone must not be subdivided into lots less than 500 square
metres.
A permit cannot be granted to subdivide land which is not in accordance with this
requirement unless:
? the subdivision is in accordance with a permit that was granted on or before 31 October
2006 for development of more than one dwelling (not a dependent person’s unit) on a
lot; or
? the subdivision includes common property, and the total reduction in the size of lots in
the subdivision does not exceed the area of the common property.. |
|
雷达卡
